基于船模的木京扩建船闸通航水流条件试验研究
DOI:
CSTR:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:


Experimental research on navigable flow condition of Mujing ship lock expansion project based on ship model
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    针对木京枢纽扩建船闸通航条件较为复杂的问题,对其上、下游引航道推荐方案的通航安全性进行试验论证研究。在水工模型试验的基础上,利用自航小尺度船模技术,观测分析船闸上、下游引航道在不同流量下的舵角、航速等通航参数。结果表明,在Q≥3 900 m3/s时,上、下游引航道均有通航参数超过相应限值,难以保障通航安全。上、下游引航道的航行难点分别在于横流较大的转弯段和导墙末端,且均表现为进闸难度大于出闸难度。综合试验成果进行定量和定性分析,提出船闸最高限制通航流量为3 000 m3/s,为工程优化设计及后期运行提供了科学可靠的数据基础。

    Abstract:

    For the complicated navigable condition of Mujing ship lock expansion project,we carry out an experimental study on the navigable flow condition in the upstream and downstream approach channels of recommended schemes. On the basis of the hydraulic model test,we use the small-scale ship model measurement and control technology to observe and analyze the navigation parameters,such as rudder angle and speed.The results show that when Q≥3 900 m3/s,there are some parameters exceeding the limit both in the upstream and downstream approach channels,which may lead to a dangerous navigation;for both upper and lower waterways,the entering of the lock is more difficult than getting out of it and the navigation difficulties are on the turning section and the guard-wall end respectively,where the velocities of cross flow are relatively high.From the comprehensive analysis of the study results,a maximum navigable discharge of 3 000 m3/s is proposed,which provides a scientific and reliable data basis for the optimal design and later operation of the ship lock project.

    参考文献
    相似文献
    引证文献
引用本文

刘中峰,刘 达,黄本胜,等.基于船模的木京扩建船闸通航水流条件试验研究[J].水运工程,2020(1):83-89.

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2020-01-13
  • 出版日期:
文章二维码